Rotating Equipment

AGITATORS – MIXERS – BLENDERS – HOMOGENIZERS
1
  • PORTABLE AGITATORS
  • GEARMOTOR MIXERS FOR TANKS
  • HIGH SPEED DISPERSION MIXERS
  • LIQUID POLYMER BLENDER
  • CHEMICAL MIXER/FEEDER PACKAGED UNITS
  • HOMOGENIZER-MIXERS
COMPRESSORS -DAMPENERS-FANS-BLOWERS
0
  • DYNAMIC COMPRESSORS
    • CENTRIFUGAL AIR COMPRESSOR WITH MOTOR
    • CENTRIFUGAL AIR COMPRESSOR WITH TURBINE
    • AXIAL (IN LINE) COMPRESSOR
    POSITIVE DISPLACEMENT COMPRESSORS
    • SINGLE RECIPROCATING AIR COMPRESSOR – SINGLE STAGE
    • SINGLE RECIPROCATING AIR COMPRESSOR – TWO STAGES
    • GAS ENGINE DRIVEN RECIPROCATING COMPRESSOR
    • ROTARY SCREW AIR COMPRESSORS
    • BREATHABLE AIR RECIPROCATING COMPRESSORS
    PULSATION DAMPENERS AND AIR DRYERS
    • AIR RECEIVERS/GAS PULSATION DAMPENERS
    • REFRIGERATED AIR DRYERS
    • CHILLER AIR DRYERS
    • AIR DRYERS, DESICCANT TYPE
    • AIR DRYER PRE-FILTERS, AFTERFILTERS AND AUTOMATIC DRAIN VALVES
    FANS AND BLOWERS
    • INDUSTRIAL AXIAL FANS
    • INDUSTRIAL CENTRIFUGAL FANS
    • POSITIVE DISPLACEMENT AIR BLOWERS
DRIVERS & TURBINES
0
  • ELECTRICAL MOTORS
    • ELECTRIC MOTOR DRIVERS UP TO 300 HP
    • ELECTRIC MOTOR DRIVERS > 300 HP UP TO 1000 HP
    • ELECTRIC MOTOR DRIVERS > 1000 HP UP TO 3500 HP
  • GEARING PRODUCTS
    • CONCENTRIC SHAFT SPEED REDUCERS
    • HORIZONTAL GEARMOTORS
  • TURBINES
    • STEAM TURBINES CONDENSING POWER OUTPUT: 10 UP TO 30.000 HP
    • STEAM TURBINES NON CONDENSING POWER OUTPUT: 10 UP TO 30.000 HP
    • GAS TURBINES POWER OUTPUT: 1,000 – 370,000 HP
    • TURBO-EXPANDER
    • WIND TURBINES
    • WATER TURBINES
PUMPING EQUIPMENT
0
  • CENTRIFUGAL PUMPS

    HORIZONTAL CENTRIFUGAL PUMPS

    • SINGLE STAGE STANDARD ANSI PUMP – HORIZONTAL OR VERTICAL END SUCTION
    • TWO STAGE, HORIZONTAL SPLIT CASE CENTRIFUGAL PUMPS
    • PLASTIC ANSI SINGLE STAGE PUMP
    • GENERAL SERVICE, CAST IRON FOR FLOWS TO 2000 GPM [125 L/S]
    • LOW CONSISTENCY PULP STOCK PUMP

    VERTICAL CENTRIFUGAL PUMPS

    • TURBINE – VERTICAL MOTOR WITH TURBINE IMPELLER FOR WET PITS.
    • VERTICAL SUMP PUMP – TURBINE IMPELLER

    INLINE CENTRIFUGAL PUMPS

    • API 610 IN LINE PUMP
    • GENERAL SERVICE IN-LINE PUMP
    GEAR PUMPS
    • STANDARD EXTERNAL GEAR ROTARY PUMP.
    • CANNED ROTOR GEAR PUMP.
    • MECHANICAL SEAL GEAR PUMP.
    • MAGNETIC DRIVE GEAR PUMPS FOR CRUCIAL LIQUID
    PISTON, OTHER POSITIVE DISPLACEMENT PUMPS
    • RECIPROCATING SIMPLEX PLUNGER PUMP STEAM DRIVER.
    • RECIPROCATING DUPLEX PLUNGER PUMP STEAM DRIVER.
    • RECIPROCATING TRIPLEX PLUNGER PUMP STEAM DRIVER.
    • DIAPHRAGM PUMP – TFE TYPE INCLUDES MOTOR DRIVER
    • RECIPROCATING PLUNGER PUMP INCLUDES MOTOR DRIVER.
    • HIGH DENSITY STOCK PUMP WITH TWIN INTERMESHING SCREW
    VACUUM PUMPS
    • HIGH VACUUM PUMPS
    • TWO-STAGE MECHANICAL VACUUM PUMPS
    • MULTI-STAGE MECHANICAL BOOSTER VACUUM PUMPS
    • VACUUM BOOSTER PUMPS
    • HOT VACUUM PUMPS
    • ROTARY VANE VACUUM PUMPS
    • VACUUM PUMP ACCESSORIES

    F1500 – AXIAL FLOW PUMPS

    • F15101 – AXIAL FLOW VERTICAL PUMPS
    • F15102 – AXIAL FLOW HORIZONTAL PUMPS
GENERATOR SETS
0

Static Equipment

PACKING & LININIG2
FlareSystem1
PROCESS COLUMNS
1
  • PACKED SINGLE / DOUBLE-DIAMETER COLUMNS
  • TRAYED SINGLE / DOUBLE-DIAMETER TOWER
PRESSURE VESSELS & TANKS
0
PACKING & LININGS
0
  • PACKING
    • E1101 – PACKING, VARIETY OF VESSEL PACKINGS
    LINING
    • E1201        ACID BRICK LINING
    • E1202        CASTABLE, REFRACTORY OR GUNNED MIX (MONOLITHIC) LINING
    • E1203        FLUOROCARBON LININGS
    • E1204        GLASS LININGS
    • E1205        REFRACTORY BRICK
    • E1206        RESIN LININGS
    LINING (Cont.)
    • E1207        RUBBER LININGS
    • E1208        LEAD LININGS
    • E1209        ZINC LININGS
    • E1210        RUBBER LININGS
    OTHER LINING
    • E1300 – LINING – OTHER THAN ACID BRICK, MONOLITHIC
FLARE RELATED EQUIPMENT
0
  • DERRICK-SUPPORTED FLARE STACK
  • GUYED FLARE STACK
  • SELF-SUPPORTED FLARE STACK
  • HORIZONTAL GROUND FLARE
  • RECUPERATIVE THERMAL OXIDIZER
  • VAPOR CONTROL FLARE FOR STORAGE/LOADING
  • STACK WITHOUT FLARE TIP

Heat Transfer Equipment

HEAT EXCHANGERS, FUEL OIL HEATERS, EVAPORATORS, CONDENSERS, COOLERS
1
  • FUEL OIL HEATERS
  • HAIRPIN TYPE HEAT EXCHANGERS
  • HEAT EXCHANGERS FOR HEATING WATER
  • TEMA R SHELL AND TUBE HEAT EXCHANGERS
  • VERTICAL TUBE SURFACE CONDENSERS AND RECEIVERS
  • ACID COOLERS
  • PROCESS PLANT COOLING TOWERS
  • INERT GAS GENERATORS
  • VERTICAL CYLINDER TYPE FIRED HEATER & BOX TYPE FIRED HEATER
BOILERS, FEEDWATER HEATERS, FIRED HEATERS AND TANK HEATING COILS
0
  • PACKAGED BOILERS
  • DEAERATING FEEDWATER HEATERS
  • STEEL STACKS FOR BOILERS
  • TANK HEATING COILS
  • FIRED TANK IMMERSION HEATERS

Material handling equipment

CoveyingEquipment2
SeparationEquipment2
SIZE REDUCTION EQUIPMENT
1
  • OVERHEAD ECCENTRIC JAW CRUSHERS
  • IMPACT BREAKERS
  • TWIN ROTOR IMPACTORS
  • RING-TYPE GRANULATORS
  • GRAVITY IMPACT CRUSHERS
  • HAMMER MILLS
  • REVERSIBLE IMPACTORS
  • SINGLE ROLL CRUSHERS
  • SINGLE ROLL FROZEN COAL CRACKERS
DRYING MATERIAL EQUIPMENT
0
BELT CONVEYORS & BUCKET ELEVATORS
0
  • TROUGHED BELT CONVEYORS
  • BUCKET ELEVATORS
  • SCREW CONVEYORS
  • TUBEFLO CONVEYORS
  • MULTIFLO CONVEYORS
SEPARATION EQUIPMENT
0
  • SCREENS AND CLASSIFICATION EQUIPMENT
    • VIBRATING SCREENS
    • FULLFLOW RECTANGULAR SEPARATOR
    • CENTRIFUGAL SIFTER
    • PRESSURE SIFTERS
    • ROTARY SCREENS
    • TURBO-SCREEN CLASSIFIERS
  • DUST COLLECTION EQUIPMENT
    • GAS SCRUBBERS
    • CYCLONE COLLECTORS
    • CENTRIFUGAL SCRUBBERS
    • FILTER CARTRIDGE DUST COLLECTORS
    • BAG HOUSE DUST COLLECTORS
    • FEEDER VALVES
  • FILTERS AND LIQUID SOLID SEPARATION EQUIPMENT
    • LIQUID CLARIFIERS
    • VIBRATING SEPARATORS
    • RUBBER LINED FILTERS
    • VANE-TYPE SEPARATORS
    • WHITE WATER FILTERS

Follow us:

Copy Protected by Chetan's WP-Copyprotect.